BG2-U01 Userlock Frp Remove CM2 Dongle

0/5 No votes

Report this app

Description

Before Unlocking The BG2-U01 Userlock Frp, Make Sure The Following Steps Are Performed:

Download Install SPD Driver

LINK – DOWNLOAD

Login Username & Password On CM2SP2

Choose Firmware PAC ROM On CM2 FDL

Download BG2-U01 Pac Firmware

LINK – DOWNLOAD

Operation : Format FS / Reset Settings [ v2.14 ]
Mode : Default [ Reset Settings + FRP ]
BootMode : FLASH

  1. Power off device, wait 10-15 seconds
  2. Press and hold BooKey ( 1 : BOTH VOL , 2 : VOL+ , 3 : VOL- )
  3. Insert cable in device!

Wait for device โ€ฆ

Device Connected!
BootVersion : SPRD3
Boot : PAC : 2019-02-25-19-26-29.pac
Sending Init Boot โ€ฆ
Boot sent!
Kick FDL โ€ฆ
Kick FDL again โ€ฆ
BootVersion : Spreadtrum Boot Block version 1.1
Protocol setup โ€ฆ
Port speed : 921600
Sending Flash Boot โ€ฆ
Boot sent!
Kick FLASH FDL โ€ฆ
FDL : Control transfered!

Boot Done!

Wipe Ok : UserData
Wipe Ok : Cache
Wipe Ok : FRP

Reconnect Power/Cable!

Done!
Elapsed: 00:00:48

Download CM2 SP2 Lasted Version

LINK – DOWNLOAD

Leave a Reply

Your email address will not be published. Required fields are marked *