Before JNY-LX2 ID Lock Remove, Make Sure The Following Steps Are Performed:
Download Huawei Com1.0 Driver
LINK – DOWNLOAD
All Huawei Test Point
LINK – VIEW
Login Username and Pass On Octoplus Huawei Tool

Huawei Com1.0 Close Error Fix

Welcome to Octoplus Huawei Software v.1.2.7
To enable ‘Manufacture’ mode dial
- for Qualcomm and Hisilicon based models: ##2846579##
ProjectMenu > Background Settings > USB Port Settings > Manufacture Mode - for MTK based models: ##14789632##
ProjectMenu > Background Settings > USB Port Settings > Debug Mode
To enable ‘Fastboot’ mode
- Power off the phone. Remove SD and SIM cards
- Press ‘Vol-‘ and insert USB cable
- Wait until phone enters ‘Fastboot’ mode
To enable ‘Upgrade’ mode
- Power off the phone. Remove SD and SIM cards
- Press and hold ‘Vol-‘ and ‘Vol+’ keys and insert USB cable
- Wait until phone enters ‘Upgrade mode’
Found COM ports:
1: COM7 USB Serial Port
2: COM29 Standard Serial over Bluetooth link
3: COM52 HUAWEI USB COM 1.0
4: COM28 Standard Serial over Bluetooth link
Job ID: 0000000001E2CB55
2021-11-28 12:50:28 GMT ————————————————-
Starting Reset Huawei ID
Selected phone model: JNY-LX2
Searching HUAWEI USB COM 1.0 port…
Detected HUAWEI USB COM 1.0 port
Writing bootloader KIRIN810_V1…
Initializing remote service connection…
Writing XLOADER partition…
Writing UCE partition…
Writing FASTBOOT partition…
Bootloader Update successfully
Rebooting to fastboot mode…
Searching Fastboot devices…
Found android device: UT7ULK203T005535
Detected Android Sooner Single ADB Interface port
Device Model: JNY-LX2
System: JNY-L22 10.1.0.363(C636E1R2P1)
Android Version: 10
Base Version: JNY-LGRP2-OVS 10.1.0.363
Custom Version: JNY-L22-CUST 10.1.0.1(C636)
Preload Version: JNY-L22-PRELOAD 10.0.1.1(C636R2)
C_Version: C636
D_Version: D000
FB Lock State: LOCKED
User Lock State: LOCKED
Connecting to the credit server…
Username: cxYQKOIZma
Checking balance…
Your balance: 150 credits
Sending device information…
Sending firmware information…
To perform this operation you need to have: 0 credits.
Removing firmware protection…
Connecting to server…
Waiting for a response from the server…
FB Lock State: UNLOCKED
User Lock State: LOCKED
Device Model: JNY-LX2
System: JNY-L22 10.1.0.363(C636E1R2P1)
Resetting Huawei ID…
Formatting secure data…
Rebooting device…
Reset Huawei ID done.
Performed by 1.2.7 Software version.
If Can’t Change Com1.0 To Fastboot [Disconnect USB / Connect Again ]

Download Octoplus Huawei Tool Lasted
LINK – DOWNLOAD
Download JNY-LX2 JNY-L22 _EMUI10.0.1 Firmware
LINK – DOWNLOAD
