Before Unlocking The Tecno BD2P Frp, Make Sure The Following Steps Are Performed:

Download Install SPD Driver

LINK – DOWNLOAD

Login Username & Password On CM2SP2

Choose SC7731E BASE On CM2-SP2

Operation : Format FS / Reset Settings [ v2.14 ]
Mode : Reset FRP
BootMode : FLASH

  1. Power off device, wait 10-15 seconds
  2. Press and hold BooKey ( 1 : BOTH VOL , 2 : VOL+ , 3 : VOL- )
  3. Insert cable in device!

Wait for device …

Device Connected!
BootVersion : SPRD3
Boot : INF : 0_SC7731E_BASE : SC7731E_eMMC_1GB_0S
Sending Init Boot …
Boot sent!
Kick FDL …
BootVersion : Spreadtrum Boot Block version 1.1
Protocol setup …
Port speed : 921600
Sending Flash Boot …
Boot sent!
Kick FLASH FDL …
FDL : 0x0008
FDL : EMMC_RO : False ; EMMC_PART : True ; EMMC_RPMB_SET : False
FDL : RAW : 0x0002
FDL : FLH : 0x400000
FDL : Control transfered!

Boot Done!

Wipe Ok : FRP

Reconnect Power/Cable!

Done!
Elapsed: 00:00:19

Download Tecno BD2P Firmware File

LINK – DOWNLOAD

Download CM2SPD Lasted Version

LINK – DOWNLOAD

By admin

Leave a Reply

Your email address will not be published.