Before DRA-LX9 (Huawei Y5P) ID Lock Remove, Make Sure The Following Steps Are Performed:
Install MTK Driver Lasted
LINK – DOWNLOAD
All Huawei Test Point
LINK – VIEW
Login Username and Pass On Octoplus Huawei Tool
Welcome to Octoplus Huawei Software v.1.2.6
To enable ‘Manufacture’ mode dial
- for Qualcomm and Hisilicon based models: ##2846579##
ProjectMenu > Background Settings > USB Port Settings > Manufacture Mode - for MTK based models: ##14789632##
ProjectMenu > Background Settings > USB Port Settings > Debug Mode
To enable ‘Fastboot’ mode
- Power off the phone. Remove SD and SIM cards
- Press ‘Vol-‘ and insert USB cable
- Wait until phone enters ‘Fastboot’ mode
To enable ‘Upgrade’ mode
- Power off the phone. Remove SD and SIM cards
- Press and hold ‘Vol-‘ and ‘Vol+’ keys and insert USB cable
- Wait until phone enters ‘Upgrade mode’
Found COM ports:
1: COM1 Communications Port
2: COM2 Communications Port
Your balance: 150 credit(s)
Job ID: 0000000001C6D41E
2021-11-07 04:42:24 GMT ————————————————-
Starting Reset Huawei ID
Selected phone model: DRA-LX9
Please, put your device in Factory mode (use “ON/OFF Factory Mode” option or Hardware Test Point) and insert USB cable
Detected MediaTek USB Port port
Detecting Chip Version…
HW Chip : MT6765
HW Version : 8A00.CA00.0000.0000
Initializing remote service connection…
Downloading Mtk Loader…
Downloading additional resources…
Writing loader…
DA successfully sent
Reconnecting…
Detected MediaTek PreLoader USB VCOM (Android) port
Downloading additional resources…
Initializing remote service connection…
Downloading secure data…
Downloading additional resources…
Reading secure data dump done!
Resetting Huawei ID…
Reset Huawei ID done.
Performed by 1.2.6 Software version.
Download Octoplus Huawei Tool Lasted
LINK – DOWNLOAD
Download DRA-LX9_CM2 Scatter Firmware_MT6765
LINK – DOWNLOAD
